Friday, March 23, 2012

Atmel to showcase power-efficient MCU solutions for industrial and consumer apps

SAN JOSE, USA: Atmel Corp. will be exhibiting a variety of its microcontroller (MCU) and embedded solutions at ESC DESIGN West 2012 Silicon Valley in San Jose, California, March 26-29, 2012.

At Atmel booth #916, attendees can see demos including:

Atmel Studio 6: A single integrated development environment supporting two of the most popular MCU architectures, Atmel ARM processor-based devices and Atmel AVR devices. This demo shows how designers can use the optimized design environment to debug 8- and 32-bit AVR MCUs and Cortex-M3-based MCUs.

Atmel AVR Solutions: A media player docking station with RF remote control, demonstrating Atmel's system solution. The demo is built on software modules provided by Atmel to help developers accelerate their software design. These solutions also demonstrate capacitive touch with proximity sensing, RF and Made For iPod (MFi) support.

A home security platform: Based on the Atmel SAM3S ARM Cortex-M3 processor-based Flash MCU, the platform uses a low-power ZigBee wireless passive infrared (PIR) motion detector camera for a secure, cost-efficient system.

A temperature sensor louver: Utilizing an Atmel UC3-L0 Xplained development board and Atmel Temperature Sensor Xplained add-on board, the system demonstrates temperature monitoring using a heat source and mechanical louver panel.

An in-home display: Using a multi-touch Android tablet featuring Atmel maXTouch technology and Atmel SAM9M10 ARM926-based embedded MCU, the in-home display will demonstrate touch capability on a low-power handheld device.

An efficient, ultra-low power MCU unit: Highlighting MCU efficiency using the Atmel AVR XMEGA MCU, this demonstration exhibits fast wake-up from low-power modes to ultra-low power consumption.

Power supply authentication: Featuring the Atmel CryptoAuthentication ATSHA204 device, this solution will demonstrate improved safety and cloning prevention.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.